Screwdriver Hex Bit holder
Copyright Claim
Screwdriver Hex Bit holder
Boost
32
47
19
Print Profile(1)
Fast! 0.3mm layer, 3 walls, 5% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
32
47
19
5
174
174
Released
Description
I designed a Screwdriver Hex Bit holder for 72 Bits. (60 small bits, 12 long bits)
Comment & Rating (19)
All
The print profile is no longer public
super nice little bit holder - nicely staggered tiers and easy to take out bits
The designer has replied
1
Reply
Thanks for reviewing, I appreciate the feedback.
0
Reply
Print Profile
Fast! 0.3mm layer, 3 walls, 5% infill
built this to organize tools... find the holes almost too tight... but works well
1
Reply
Print Profile
Fast! 0.3mm layer, 3 walls, 5% infill
Still trying to find a good fit. 100% is too tight, 104% is too loose.
0
Reply
Print Profile
Fast! 0.3mm layer, 3 walls, 5% infill
great idea and great design
unfortunately the openings are too small, after I enlarged the model to 104%, the bits fit perfectly
0
Reply
Print Profile
Fast! 0.3mm layer, 3 walls, 5% infill
the project printed ok but the hex holes are too tight. the hex bits fit but I had to use pliers to take them out
0
Reply
Print Profile
Fast! 0.3mm layer, 3 walls, 5% infill
It was a little too tight. I added 0.25mm hole expansion and its better now.
0
Reply
Found the holes too tight to use, printed on an x1c and have not had tolerance issues with other prints. Nice design though
0
Reply
Boosted
Print Profile
Fast! 0.3mm layer, 3 walls, 5% infill
0
Reply
Print Profile
Fast! 0.3mm layer, 3 walls, 5% infill
0
Reply
Print Profile
Fast! 0.3mm layer, 3 walls, 5% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld