Sanlight Q1W (Dim) Mounting Bracket for Ceiling
Boost
2
4
1
Print Profile(2)
0.2mm layer, 3 walls, 35% infill
Designer
2.5 h
1 plate
0.6mm nozzle, 0.18mm layer, 3 walls, 40% infill
Designer
2.6 h
1 plate
Boost
2
4
1
0
3
1
Released
Description
I was disappointed of the Mounting of my Sanlight Q1W Growlight.
Made my own version to mount it on the ceiling to shine on my living green wall.
your need 2xBolts M4 with Nuts to connect the two brackets.
2 Wood Screws 4,5mm to Mount it on the Ceiling and 2 M4 Bolts to screw the printing on the lamp itself.
I used a M4 thread cutter to drive it into the little holes where the original Wireclips are inserted.
fits perfectly and it is a good connection
I used PETG Filament because of the higher Heat resistance (Lamp will gets up to 60°C)
The extra Bar is mounted on the other side of the Lamp to get rid of the side-light-leaking of the Spot. an is also attached with 2 Bolts M4.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 3 walls, 35% infill
printed great needed your mount to
hold small solar panel
thank you
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld