Exaclty what I was looking for. The print itself was trouble free, but the inserts to hold the cable are too tight and I could only get one in, no matter how hard I tried.

hellojoe

0.28mm layer, 2 walls, 10% infill

Worked fine for AMAZON Basics spools.  I made a remix for SUNLU spools.  

crackFinder

Is it possible to get the dimensions of the Esun spool? I've got a pile of Kingroon spools I'd like to use this on, but not entirely sure if it'll fit properly. The ID of the spool for the Kingroon is just a hair under 58mm.

Kyesniper

Exactly what I was looking for. I've got so many empty eSun spools going to waste, this will allow me to re-use them

euan.webster

UoAoE3D

cover

plate_3.webp

plate_1.webp

plate_2.webp

Cord Snap

plate_1.png

Side PL,Screw,Nut,Wrench

plate_2.png

Handle ,Spool Spacer

plate_3.png

I used PETG to print the files, however, you could choose any material you like<ul><li>(keep in mind that if you will use it outdoors then a suitable material is needed)</li><li>(No-Brim is active in all plats, enable it if you needed it)</li></ul>Description of the plats:<ul><li>Cord Snap plat: Only one set is needed, move the chosen set to the next plate and print</li><li>Side PL,Screw,Nut,Wrench plat: All are needed</li><li>Handle ,Spool Spacer plat: Support is enabled for the Handle with support interface using PLA, you can do without</li></ul>

Dual Spool Cord Wrap

a Remix that will fit into eSUN PLA+ spools, only 2 parts was remixed the rest are from the original design by AndrewRoth - modified (Just Shorter) Generic Barrel Screw - Spool Spacer to give the Generic Side PL a better fitment

Print Profile(1)

Description

Comment & Rating (4)

This remix is based on

License

Related Models

Charging cord reel

Dual Glasses Stand

Dual color coaster with holder (without AMS)

Dual Dog/Hiking Keychain Whistle

eSUN Dual Spool Cord Wrap