Small Container / Desiccant Container
Copyright Claim
Small Container / Desiccant Container
Boost
27
51
12
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
47 min
1 plate
0.28mm layer, 3 walls, 10% infill
39 min
1 plate
Open in Bambu Studio
Boost
27
51
12
5
122
128
Released
Description
A small container for various uses.
May be used for desiccant.
Comment & Rating (12)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
I managed to fit 10 of these in a single plate and they printed great. I had expected the lid to be a screw on type lid like all of the other desiccant containers I have used, but was disappointed to discover that it's a snap-on and is incredibly difficult to remove especially if you have any hope of not spilling silica beads everywhere.
I will use the set that I printed, but probably will not make any more.
1
Reply
Print Profile
0.28mm layer, 3 walls, 10% infill
Ein sehr guter Druck. Zu beachten sollte sein das es kein Schraubgewinde ist sondern eine Steckverbindung. Fittet dennoch sehr gut 🤝🏻
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
printed great tolerances fit well
(Edited)
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
good
0
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
Prints perfectly and everything works/fits. In my case printed with PA6-CF from Polymaker.
(Edited)
0
Reply
Print Profile
0.28mm layer, 3 walls, 10% infill
These worked out great for me!
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
great little container. top snaps on micely
0
Reply
Print Profile
0.28mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 3 walls, 10% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld