A Spiral Inspired Wall Shade that prints easily in 3 Separate Parts. Assembly is not so complicated but you would have to know how to solder two wires to the LED Strip.

Dimensions:
Length: 260mm
Width: 150mm

Description of Parts to Print:

1.Lamp_WallPlate - This is used to connect to the wall via your household electrical wall connections with two 5mm bolts.

2.Lamp_BackPlate - This is used to place the transformer inside and attach the Spiral shade to it via two 3mm bolts. Once assembled it then has two holes (top and bottom) as seen in the renders to attach to the WallPlate.

3.Lamp_Spiral - The spiral has two flush cut ends on the back so you can press it against the Backplate and use two 3mm screws to secure it to the BackPlate. The spiral also has a groove that is 8.10mm wide and 1.9mm deep to insert the LED Light inside. On the top end, the Spiral also has two additional holes (shown only from the back) to pass the wiring through two channels to be able to hide the wires which will be soldered to the LED Strip.

Link for the products I used:

LED Strip:
Warm White 300k, 24V 8mm Width
https://www.aliexpress.com/item/1005002229402699.html?spm=a2g0o.order_list.0.0.1e901802rvinqD

Transformer:
24V1.5A 36w (in my country we use 240V mains current)

https://www.aliexpress.com/item/4000618465817.html?spm=a2g0o.order_list.0.0.1e901802rvinqD

Please note that if you buy different LED Lights you need to make sure you are using the correct transformer, and vice versa.

Should you require further help please do contact me.