X1C hotend plug removing tool
Copyright Claim
X1C hotend plug removing tool
Boost
3
8
3
Print Profile(1)
0.08mm layer, 4 walls, 15% infill
Designer
17 min
1 plate
Open in Bambu Studio
Boost
3
8
3
1
14
11
Released
Description
This simple tool makes it a bit easier to remove the plugs from the hotend without damaging any wiring, or putting undue strain on the printhead.
The tool is used as follows. :-
Heater: slide it over the plug and pull.
Fan: push it over the ridge. I put the lower edge over first then the top edge. It will click over then pull.
Thermistor: slide over the connector with the arms top and bottom, pull with a slight upward force on the tool so it grabs the bottom edge, which is also a release catch. It should come out very easily.
It's not perfect as the tool is so small it is almost beyond the detail required with a .4mm nozzle. It would probably print really nicely on a 0.2mm nozzle.
Comment & Rating (3)
All
Print Profile
0.08mm layer, 4 walls, 15% infill
Mit 0,2mm Düse gedruckt, kam gut raus. Der Einsatz des kleinen Helfers möchte trotzdem geübt werden.
0
Reply
Printed this in Tough PLA in anticipation of swapping out my hotend. So glad I did - it made unplugging everything so much easier.
0
Reply
Boosted
Print Profile
0.08mm layer, 4 walls, 15% infill
Very handy tool! Easy to print with PLA-CF and looks nice.
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld