Cancer/Butterfly Ribbon Lightbox
Cancer/Butterfly Ribbon Lightbox
Boost
10
16
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
6.4 h
3 plates
Open in Bambu Studio
Boost
10
16
5
0
18
22
Released
Description
Breast Cancer Awareness Lightbox
USB Lights used 5v Cob LED lights off Amazon Link if needed https://a.co/d/4ibaDFv
No Support Needed
No Brim
Watch for Wisps but the settings should tame most of them.
Comment & Rating (5)
All
Not sure how well this was tested but I have printed the back twice on two diferent printers and it does not fit, it is too big. I am now trying it at 97% size to see if it will fit on.
0
Reply
Did that help
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:back doesn't fit on
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues:extremely tight clearance. no matter how many times I tried I could not get the back to fit on.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld