If you print a wakeboard hook then the second hook must be mirrored.

There is a difference between snowboard and wakeboard hooks. Wakeboard hooks are 4º inclined to match the curvature of the board.

For booted wakeboard 30 degree hooks, I recommend using a stronger filament. PLA can bend over time, especially if temperatures are high in the room. Wakeboard without boots on PLA 30 degree hooks, I believe it works. Haven't done any serious testing

• Resolution: 0.2 mm
• Wall loops: 5° hook 5-loops / 30° hook 10-loops
• Infill: 5° hook 20% / 30° hook ~40% but more is better
• Material: PLA , PETG
• Supports: No
• Brim No

Screw hole

• Diameter : 5.2mm, 0.2 inch

Hole Length :

• Hook D1 - 28mm, 1.10 inch
• Hook D2 - 25mm, 0.98 inch
• Hook D3 - 15mm, 0.59 inch
• Hook D4 - 13mm, 0.51 inch