I wanted to mount a some Skadis boards at the side of my printer. If found the original model by hairyfacedhooman but wasn't 100% with that.

I added a little spacer, so it fits with my AMS riser. In addition I added some hooks, because I printed the Skadis boards myself and therefore didn't have the original mounting hardware.

The uploaded model is for mounting on the right side of the AMS. I haven't tested the left side, but I'm very sure, that the model just needs to be mirrored and should work then.

I also haven't tested with the older version of the AMS, but as far as I know it shouldn't work there.

Be careful when removing the supports from the hooks, they tend to break off.