Nightlamp Paw Patrol
Copyright Claim
Nightlamp Paw Patrol
Boost
60
100
31
GIF
GIF
Print Profile(3)
0.16mm layer, 999 walls, 0% infill
Designer
3.6 h
1 plate
one light, 0.2mm layer, 3 walls, 15% infill
Designer
31 min
1 plate
two lights, 0.2mm layer, 3 walls, 15% infill
Designer
48 min
1 plate
Open in Bambu Studio
Boost
60
100
31
2
167
190
Released
Description
Small nightlamp with battery powered LEDs in Paw Patrol design.
Can be used with this kind of “balloon-lights” (see link below):
> two pieces can be put inside the small threaded sleeve (without glue). Then screw it into the bigger one.
Can be used with this kind of small LED light (see link below):
> add one piece inside the sleeve (with some glue on it to prevent rotating when switching on the light).
Comment & Rating (31)
All
Print Profile
0.16mm layer, 999 walls, 0% infill
A bit small, but fine in the end 😉
I made a custom cover and bottom for it, with led light inside (but I forgot to take a photo..)
1
Reply
Print Profile
0.16mm layer, 999 walls, 0% infill
I modified it a little bit for the LED strip, but otherwise its excellent!
1
Reply
Print Profile
0.16mm layer, 999 walls, 0% infill
Perfekt geworden, hatte es mir etwas grösser vorgestellt
1
Reply
Boosted
Print Profile
one light, 0.2mm layer, 3 walls, 15% infill
good print. thnx
1
Reply
Print Profile
two lights, 0.2mm layer, 3 walls, 15% infill
everything performed the way it was designed
1
Reply
Print Profile
0.16mm layer, 999 walls, 0% infill
Magnifique lampe pat patrouille . C'etait ma premiere lithophanie et elle est parfaitement reussi . et le trou pour une lampe a led est nickel 👌🏼
1
Reply
Print Profile
0.16mm layer, 999 walls, 0% infill
1
Reply
Print Profile
one light, 0.2mm layer, 3 walls, 15% infill
1
Reply
Boosted
Print Profile
0.16mm layer, 999 walls, 0% infill
1
Reply
Boosted
Print Profile
two lights, 0.2mm layer, 3 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld