Abdeckung für Loch am Gehäuse P1S
Copyright Claim
Abdeckung für Loch am Gehäuse P1S
Boost
4
12
6
Print Profile(1)
0.2mm layer, 5 walls, 30% infill
Designer
11 min
1 plate
Open in Bambu Studio
Boost
4
12
6
0
19
13
Released
Description
stopfen für das loch an Gehäuse
Comment & Rating (6)
All
Print Profile
0.2mm layer, 5 walls, 30% infill
passt
0
Reply
Print Profile
0.2mm layer, 5 walls, 30% infill
schöner Druck, sitzt bei meinem P1S ein bißchen locker aber macht was es soll,nämlich das Loch verschließen.
0
Reply
Very good profile und modell
0
Reply
Print Profile
0.2mm layer, 5 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 5 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 5 walls, 30% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld