Search models, users, collections, and posts
Tabletholder extender
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 25% infill
Designer
39 min
1 plate
Open in Bambu Studio
Boost
2
7
1
0
7
2
Released
Description
I created an extender piece for the Telescopic tablet holder which I bought on Aliexpress.
My car (Kia EV6) did not allow a direct fit due to the headrest design, so to overcome this I needed an extender.
Extra requirements:
1x M4 35mm screw
1x M4 hexnut
Advice:
Print this piece in PETG to withstand the heat during the summer.
PLA wil deform (trust me, I tried)
(This piece will carry the weight of the tablet and/or any abuse from the child)
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (1)