WeCreat Rotary Extensions
Copyright Claim
WeCreat Rotary Extensions
Boost
13
25
5
Print Profile(1)
0.2mm layer, 4 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
13
25
5
1
117
41
Released
Description
Here are some rotary extensions which I created in order to get away from the way too large “none print zone” issue on the laser. I would recommend printing these in PLA lating down to have the stiffness required. They use the same screws and fit on the rotary as the original clamps do.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 4 walls, 15% infill
Absolutely perfect! Exactly what I needed. Thank you!!!
(Edited)
1
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
Printed perfectly, haven’t tested yet
1
Reply
Worked perfectly! Finally, I can engrave the whole tumbler and have all of the tumbler as the work area. With a test print, it works well with engraving as well. 5 Stars!
(Edited)1
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 15% infill
WORKS AS ADVERTISED!!! THANK YOU!
0
Reply
Print Profile
0.2mm layer, 4 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld