Neutron Car - RC CyberBrick car

Neutron Car - CyberBrick RC Car

Full suspension RC car powered by Cyberbrick.

All parts that are needed for this project are included in standard CyberBrick Kit ( no additional stuff like bearings needed).

it's able to jump from heights (up to 20-25cm) . This car is build to be as much simple to assembly as possible with smallest possible number of non-printed parts. It's ideal project for weekand evening with kids or friends.

Controller

Drive System

Neutron for now uses 030 motor form LA024 Kit that comes with cyberbrick kit. It is used here to allow more people to build this project without a need for additional parts. 

With this weak motor Neutron can achive decent speed which allows him to jump and climb on elevated surfaces.

However in future I plan to add modified version for better motor, giving it a lot more speed and power.

How to print it ?

Before printing make sure to clean your bed, this model it's not that easy to print and have some tricky parts for which you need good bed athesion so before printing take a moment and clean it in your kitchen sink like you do with normal dishes. Then dry it and you are good to go 😊👌.

Material → PLA Basic 

You Have to print 3 files :

1.Front assembly

2.Base assembly

3.Back assembly

Model is splitted to 3 assembly parts because of it's complicty. Assemble it along with instruction provided below.

Some parts might need a bit of trimming at first layers to better fit.

Don't forget to Boost Like and Comment.

Thanks for visiting this post and i wish you good prints only 😉🐱👤💥

Not suitable for children under 13 years old. Minors should be supervised by an adult when playing the CyberBrick toys.