Minecraft Panda from the Trails & Tails Event

I scaled it to 300%

dimensions:

length: 6cm

width: 3,6cm

height: 3,6cm

If you like to use my method of supports :

To ensure a really clean surface of the belly I used a technique invented by a german youtuber @Manbo3D,

using PETG for the connection between the support and the first layer of the supported model.

Since PETG has different characteristics than PLA , it doesn't really connect to PLA, resulting to a really clean surface.

Removing the supports will also be way easier than with normal PLA supports.

Important information:

1. be sure to set the flushing volume from the black PLA to the PETG (support) to 750 to ensure a clean print. (as you can see in the picture)
2. After removing the PLA support, the PETG support layer will still be sticked to the model. Just gently remove the PETG layer with a knife or a sharp object and it will come off really easy (I used a cutter knife).
3. Also ensure that you choose the right Filament (PETG) at the “support /raft interface” settings

I will also upload a version with normal support settings.

As always, I would like to hear your feedback!