Hueforge print of a baby penguin I found on google, the grey in person looks fluffy so it makes for a very nice print.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:

PLA+ Sunlu Black Transmission Distance: 0.6

PLA+ Sunlu Grey Transmission Distance: 2

PLA Generic White Transmission Distance: 7

PLA+ Sunlu White Transmission Distance: 5

Swap Instructions:

Start with Black

At layer #9 (0.8mm) swap to Grey

At layer #13 (1.12mm) swap to White

At layer #19 (1.6mm) swap to White for the rest.