XL Egg Spiral (30 eggs size L)
Copyright Claim
XL Egg Spiral (30 eggs size L)
Boost
37
58
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
18.2 h
1 plate
Boost
37
58
8
0
129
12
Released
Description
XL Egg Spiral for about 30 size L eggs. This is a very large model, uses a lot of filament (about 600g). It can be printed without support, but the bottom part of the spiral could have some minor esthetical defects. It can take 17 to 21 hours to print with the standard settings.
I will try to make a smaller one, because this is only usefull for commercial use or big families!
Comment & Rating (8)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Von oben geht's, aber von unten. Einige layer wurden in der Luft gedruckt.
The designer has replied
1
Reply
Should I add supports to the profile? I was worried about the supports roughing up the top surfaces.
0
Reply
ohne Support.
(Edited)1
Reply
printed really good just a long time but works great for my farm fresh eggs
0
Reply
you planning on uploading a file or is just for sale only?
0
Reply
do you charge for this now as there is no files to print. thanks
0
Reply
What material did you use? looks great!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld