Spool Desiccant Holder
Copyright Claim
Spool Desiccant Holder
Boost
34
106
35
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
3.8 h
1 plate
0.2mm layer, 2 walls, 15% infill
3.8 h
1 plate
Open in Bambu Studio
Boost
34
106
35
13
201
217
Released
Description
Desiccant holder for the center of filament spools. Tried a few of the ones already available, but kept having an issue where when removing the spool from the AMS the holder would slide out and drop on the floor. Decided to design my own from scratch that has won't fall out of the spool and also has a cap inside the container so once the outter cap holding it in the spool is removed, the desiccant is still contained.
Comment & Rating (35)
All
Worked perfect on my X1 Carbon. I store my filament in a vacuum bag.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Merci pour le partage 👍
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The print works great! Thanks!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect!!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
prints well and works great
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed very well in petg. slow printing but screws together nicely.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Printed perfectly with PLA and PETG. Thanks!
0
Reply
Boosted
Printed a bunch of this, very good design. It's a perfect fit for Bambu Lab and cardboard Esun spools. I tried it on some Anycubic spools too and, even if the middle hole is much langer, it still stays put once screwed in.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good model
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld