Sink Caddy + Scrub Daddy / Scrub Mommy Holder by Nightthorn

Nightthorn

Household>Other House Models

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 25% infill

Designer

3.9 h

1 plate

4.8(4)

Boost

Released

Description

My wife needed a container to hold all of the dish cleaning tools. We got a scrub mommy (highly highly recommend) and didn't really have a spot for it. Rather than make the caddy pockets bigger and take up more sink space, i just added a holder on the side.

The top hanger thing in the middle is a bit sketch, so I would print this in like 25% infill just to be safe. It is a tad big for my sink so it wobbles and moves around, so measure your sink divider and this caddy and scale accordingly.

Comment & Rating (10)

@user_3146264371

Great job! My wife loves it, I had to make the middle a bit wider to fit my sink middle. But I love it, printed in PETG

@robertsbrian420

Print Profile

0.2mm layer, 3 walls, 25% infill

great but could use a fillit under the corners not to break as easy.....IDK how to do it or I would...

The designer has replied

@Nightthorn

the corners on the top part that hangs over the middle of the sink?

@robertsbrian420

on the corner broke clean off for me 😞

@floppy3D

Print Profile

0.2mm layer, 3 walls, 25% infill

works great but decided I don't like it taking up room in my sink, will look for one that sits on the bench instead, no fault of the design, just changed my mind haha

The designer has replied

@Nightthorn

@floppy thank you for the rating, despite not using it! It does take up space and sorta gets in the way and catches the plates sometimes, but it does what I needed it to until we buy a farmhouse sink lol

@user_1253398814

Print Profile

0.2mm layer, 3 walls, 25% infill

(Edited)

The designer has replied

@Nightthorn

@user_1253398814 uh oh. what problems did you run into?

(Edited)

@user_1253398814

there was some a lot threading on the bridge between the two sides. but seriously I’m sure if I printed it today all would work out. Had a few weeks or so of troubles to get the printer back running.

(Edited)