Golf Ball Marker - Get in the Hole
Copyright Claim
Golf Ball Marker - Get in the Hole
Boost
30
37
9
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
2.6 h
1 plate
Open in Bambu Studio
Boost
30
37
9
1
69
59
Released
Description
Golf ball marker for the use on the Putting Green.
Design with a hollow inside to suit 20mm x 3mm Magnet so you can attach to your hat or other places.
Pause added to allow safe deposit of magnet.
Comment & Rating (9)
All
I am printing it text down. As such it seems the pause is not correct and is too late. Does this make sense? Should I print it text up? In the pic it looks face down.
The designer has replied
0
Reply
I printed text down as well to get the nice clean look.
The pause worked off the profile I was running.... It is supposed to pause at the start of the layer that it closes over the magnet hole.
Are you able to swap the pause layer to suit your print settings?
0
Reply
Replying to @cori.hart
I did , I realized I may have changed the layer height so obviously that would.throw it off.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
great gift
1
Reply
Nice model. Could you make one without space for the magnet.
A little too big for use on a hat.
But perfect for the pocket, and then no need for the magnet. :-)
The designer has replied
0
Reply
I'll Upload a copy with no magnet hole shortly.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thanks for your rating
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
1
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld