Awesome print, my daughter just Loves IT!! I did add a little "pizazz" to the stem though!! I printed with Overture Stone PLA (looks like marble) and used some Silk Gold PLA for the gold band at the top of the 1st section of the steem! Turned out Beautiful! Thanks for the file!
Is the design intended for the 'big' pole to fully seat into the base, or sit on the little lip? I ask because it might just be my printer but i'm not able to fully seat it, i plan on maybe trying to take away some material. If it's designed to sit on the lip its not staying for me, probably will have to glue it.
The intention is for it to fully seat it.
A few options you could consider, some more obvious than others, of course:
- Sanding down or trimming down the inside ring or the outer diameter of the pole. I think I’d first try grabbing it with sandpaper and spinning it to sand it down
- Print a quick test piece like an inch of the pole at 99, 98% etc until it fits in nicely and the print all the pieces above it at that scale
- Use a heat gun or maybe even a blow dryer to slightly soften the pole before trying to insert it.
Good luck!