Adjustable Spool Holder
Copyright Claim
Adjustable Spool Holder
Boost
5
2
4
Print Profile(1)
0.2mm layer, 2 walls, 30% infill
Designer
40 min
1 plate
Boost
5
2
4
0
21
15
Released
Description
Super Simple adjustable spool holder. Print 2 pairs of brackets, put a 608 bearing on each stud and press the brackets together.
Here is the original model to see how it looks minus mounting to the top of the Ender obviously.
https://www.thingiverse.com/thing:2514285
Comment & Rating (4)
All
Print Profile
0.2mm layer, 2 walls, 30% infill
Would not stay together. Needed glue. I found a different design that was press fit for the bearings and was print in place so it would just be folded up. Worked was better and feels much more solid than this design.
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 30% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld