Search models, users, collections, and posts
Leveling Cone
IP Report
Print Profile(1)
0.2mm, 3 walls, infill: 10% adapt + 25% triangle central
Designer
8.2 h
1 plate
Open in Bambu Studio
Boost
4
7
2
0
9
7
Released
Description
Content has been automatically translated.
A simple leveling cone. Each level increases by about a centimeter. It is slightly conical because I need to level the feet of lamp or speaker stands, so the cone shouldn't allow them to slip sideways. I added a modifier in the center so that the weight bearing area is well reinforced, and I printed them without a bottom for better ground grip. Printed in PETG for greater outdoor durability, but I think they are quite solid in PLA as well. Profile with 4 prints, but I think 5 would also fit on the plate, since each one is 5cm wide by 15cm long.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)