PS5 Headphone and controller stand in two peaces for less filament
Remixed by
Copyright Claim
PS5 Headphone and controller stand in two peaces for less filament
Remixed by
Boost
16
27
4
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
11.8 h
1 plate
Open in Bambu Studio
Boost
16
27
4
2
71
21
Released
Description
I also prepared a print with the top cut off, if the user wanted to reduce the size. I prefer to use a little more filament and not end up with a quality piece.
Update: Corrected top Z distance to 0.2 because it is too hard to remove support
Comment & Rating (4)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Great looking print but man taking those supports of was a chore!
The designer has replied
0
Reply
yes is a nightmare 🙈
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
I changed the model a little but used the settings from the profile. Printed everything with no problems.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld