Grass evolution 2 - HueForge (AMS / no AMS needed) Bulbasaur / Ivysaur / Venusaur
Grass evolution 2 - HueForge (AMS / no AMS needed) Bulbasaur / Ivysaur / Venusaur
Boost
41
63
8
Print Profile(1)
AMS
Designer
5.1 h
1 plate
Open in Bambu Studio
Boost
41
63
8
1
59
49
Released
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
You can complete this print without an AMS. Use the profile that says NO AMS and it will pause at the correct height instead of doing a filament change. At that point you change your filament and let it continue until the next pause where it will wait for the next manual filament swap.
Filaments Used:
PLA Eryone Black Transmission Distance: 5
PLA Eryone Green Transmission Distance: 5
PLA Eryone Yellow Transmission Distance: 5
PLA Eryone White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Green
At layer #17 (1.44mm) swap to Yellow
At layer #20 (1.68mm) swap to White for the rest.
Comment & Rating (8)
All
Print Profile
AMS
perfect, I can't wait to print the whole complete set!
(Edited)
The designer has replied
1
Reply
Thank you
0
Reply
Print Profile
AMS
love the evolution
0
Reply
Print Profile
AMS
0
Reply
Print Profile
AMS
0
Reply
Print Profile
AMS
0
Reply
Print Profile
AMS
0
Reply
Print Profile
AMS
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld