Curtain stopper
Copyright Claim
Curtain stopper
Boost
5
11
3
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
15 min
1 plate
Open in Bambu Studio
Boost
5
11
3
2
29
34
Released
Description
I printed this in Nylon (bad finish because of 0 cooling but strong as heck) buy I assume this would also work in ABS or hard TPU. PLA I'm not sure because you need some flex for it to be able to clamp nicely
Print with supports in this orientation for highest strength
The most important dimensions you can find in the pictures. Also included the Fusion 360 file if you'd want to modify for your curtain rail
Comment & Rating (3)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
these can be a bit fragile when you print them in PLA. I would recommend to use stronger filament and printing a couple more than needed because I broke a lot of them while undoing the support.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld