Spool silica gel container dryer
Copyright Claim
Spool silica gel container dryer
Boost
31
101
12
Print Profile(1)
0.2mm layer, 1 walls, 0% infill
Designer
2.6 h
4 plates
Boost
31
101
12
1
110
123
Released
Description
Size M should fit most of spools.
Lid: slide it from side.... use some tool to get it over first counter. Then is should be easy to slide all the way.
To remove lid use small stick (2mm allen key) in the hole.
I printed lids without top/bottom layers, only hexagonal infill + perimeters.
Printed from PET or PETG. Then I can dry it in food-dryer on 70°C (together with filaments).
Comment & Rating (12)
All
Queda perfecto, mejor solución que el que va en el centro de la bobina.
Impreso en modo vaso con el ancho de línea subido a 0.6
-----------------------------------------
It fits perfectly, a better solution than the one that goes in the center of the spool.
Printed in vase mode with the line width raised to 0.6
Sorry for the translate
(Edited)
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Strength Issue:too thin, it broke with just looking a it .
The designer has replied
0
Reply
Just VASE mode -> always one perimeter. You need the right material and temperature.
(Edited)1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Perfect print :)
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Thanks for sharing
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Nice tool set!
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
Strength Issue
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
Print Profile
0.2mm layer, 1 walls, 0% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution
© 2024 MakerWorld