Ottimo file si stampa facilmente senza supporti.
unico neo riguarda i pin di attacco dei bambini con la basetta, un po troppo giusti, faticano a entrare rischiando la rottura del pin.
----
Excellent file, prints easily without supports.
the only flaw concerns the attachment pins of children with the base, a little too right, they struggle to enter risking the pin breaking.
ciao ho messo il file con supporti così che il PIN non si difformi troppo durante stampa e che poi si incastri giusto senza ulteriori movimenti mi fa piacere che ti piaccia il modello buonagiornata
hello to make it thinner just use the cut function on the slicer eliminating the back, important to leave the whole interlocking feet of the base I hope I helped you good printing
Here's my print, I slowed the initial layer to 35mm/s ( from 50) and 300mm/s travel speed from 500 and probably should have for the first few layers. Had some imperfections with the girl. Probably just my filament/printer, doubt it has anything to do with the original file. I scaled the 1st plate to 100% down from 120%. I had a little trial and error with the base since it was 100% I ended up scaling to 90% which was maybe slightly too large. I'll give the main plate another go. I really like this, kudos to the designer!
The brim and tiny supports came off perfectly!
Just for anyone else looking to scale down, since they are scaled different, you have to reduce them equally. So 120 -> 100 is a 16.66% reduction, so setting the base to 83.34 (100-16.66%) would be an equivalent reduction.