Spray-can holder
Copyright Claim
Spray-can holder
Boost
65
172
8
Print Profile(1)
Basic PLA Print - 0.28mm layer, 2 walls, 15% infill
Designer
25 min
1 plate
Boost
65
172
8
3
178
131
Released
Description
This is a re-upload of Mostlighting's Spray-can holder (and photos) from Thingverse. I am not him, but I really like the design!
If you find these useful and you want to tip the author, go to his Thingverse page.
I just want to ensure that this model is available in Makerworld, according to author license.
Author notes:
- This is a chain style can holder, you can connect them as much as you need.
- Move one side slightly up to make inclain that prevent the can from falling down (it works fine even if its level).
Comment & Rating (8)
All
Print Profile
Basic PLA Print - 0.28mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Boosted
.
0
Reply
Print Profile
Basic PLA Print - 0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Basic PLA Print - 0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Basic PLA Print - 0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Basic PLA Print - 0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Basic PLA Print - 0.28mm layer, 2 walls, 15% infill
1
Reply
Print Profile
Basic PLA Print - 0.28mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld