• all parts snap together
• only 18g of filament is needed
• maximum spool width is 40mm, if you need longer one, scale the length in your slicer
• height of the spool: 50mm from top of its opening to the bottom :)

Printing instructions:

• PLA or PETG is OK
• you need to print:
  • 1x LEFT
  • 1x RIGHT
  • 1x ROD
  • 1x BRACE
• print orientation as per picture - no brim, no supports
• I strongly recommend to print the rod SEPARATELY, or add brim if you have low bed adhesion
• use max layer height possible - pictured is 0.32mm @ 0.4mm nozzle
• use 4 perimeters and 15% infill (rectilinear)

Version history:

v1.1
18.2.2024

• added bottom brace - snaps on and fixes wobble of the stand

v1.0
26.1.2024

• initial release