Cap for top hole
Copyright Claim
Cap for top hole
Boost
133
279
140
Print Profile(3)
0.12mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
0.12mm layer, 2 walls, 15% infill
15 min
1 plate
Save a few minutes 0.24mm layer, 2 walls, 12% infill
9 min
1 plate
Boost
133
279
140
2
719
716
Released
Description
I have no need for the hole located on the top front mount of the chassis of my P1P.
So, I thought it would be enjoyable to cover it, primarily for fun but also to impede air flow. (It works on P1S too)
Print:
Resolution: 0.12
Filament: Any
Assembly:
Just push it down.
Comment & Rating (140)
All
Print Profile
0.12mm layer, 2 walls, 15% infill
Ist gut und verhindert, dass Staub hereinkommt!
- Gedruckt in 0,12 mm Fine, mit 15 % Füllung, 2 Wandlinien und 20 min Druckzeit
- Bambu ABS Marineblau (40602) in weniger Speed und ohne Support
2
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
I dont know why, but this profile scrapped on the back of my bed. the print was good.
The designer has replied
1
Reply
That's where your printer cleans the nozzle. It happens every time you start a print.
(Edited)5
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
nothing to declare. just works
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Passt perfekt
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Printed beautifully in TPU
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Does what it says on the box.
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Perfect fit. Thank you for sharing, that hole bugged me since the beginning. 😄
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
fantastic!
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
good
(Edited)
1
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Stl ok si adatta perfettamente
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld