Lovely Rose with Stem, Blooming Valentine Gift by peterow

peterow

Household>Decor

Print Profile(6)

All

P1P

P1S

X1 Carbon

X1E

ROSE - 0.2mm layer, 15%infill

Designer

1.6 h

1 plate

4.8(38)

SEPAL_v2

Designer

34 min

1 plate

4.8(13)

Stem with Base 0.2mm layer, 15% Infill

Designer

2.2 h

1 plate

4.3(18)

Sepal - 0.2mm layer, 15% infill

Designer

29 min

1 plate

5.0(5)

Click to see more

Boost

262

418

623

985

Released

Description

🌹 Add a touch of romance to your space with our lifelike 3D printed rose! 🌿

Crafted with care, this beautiful rose replica brings the beauty of blooming roses into your home all year long. 🌹💖

Perfect for Valentine's Day or any day you want to express love, this easy-to-assemble rose is a lovely addition to your decor. 🎨✨

Surprise your special someone and bring everlasting elegance to your surroundings – order yours today! 🛍️🌟

Easy to assembly

Model Information

There are a few print profiles with multiple version of Sepal and Stem/Base.

I hope the title of print profile is understandable.

Sepal

There is two version of Sepal.

Left side - V1 - Suggested Supports

Right side - V2 - No Support needed

Stem

There is two version of Stem.

Left - with Base

Right - without Base (use Brim with big surface to avoid ‘spaghetti)

Printing:
0.2-0.24mm Layer Height

Support recommended but not required
Support required only for Sepal

Comment & Rating (91)

@user_28595563

Print Profile

ROSE - 0.2mm layer, 15%infill

came out perfect! lower left, orange rose

@koch.leon1998

Print Profile

Stem with Base 0.2mm layer, 15% Infill

Looks super great and was easy to print. I hat the Issum that the last layers of the Stem wäre not printer good because the Stem was wiggling on the plate. I canceled the print but it nevertheless works an looks awesone!

@jurors.poppies0

had exactly the same (with X1).

@sm4lltig3r

Print Profile

Stem with Base 0.2mm layer, 15% Infill

Simple And great print!

@sm4lltig3r

Print Profile

ROSE - 0.2mm layer, 15%infill

It was a bit difficult to print, but I managed 😅

@BigJay

Print Profile

SEPAL_v2

Very easy to print, looks great on the flowers.

@BigJay

Print Profile

ROSE - 0.2mm layer, 15%infill

Beautiful flowers and bouquet. you need a wide opening vase though so bear that in mind. Printed supper easy. The stems are somewhat fragile but that's just the length and height. FYI - I used another model's leaves.

@inkyalan

Print Profile

ROSE - 0.2mm layer, 15%infill

the rose head printed great

@inkyalan

Print Profile

Stem with Base 0.2mm layer, 15% Infill

tried to print this twice and each time the top part of the stem ends up bad (see photo) both times have been different heights, this one I ran slower so the messed up part was shorter than the first one. I I’m printing it at 50% scale so could that be the reason?

@jurors.poppies0

The rose itself, and the leaves came out great. The stem however, did turn out great, except for the top, where the stem started to wobble. Apparently you cannot upload a short movie here, so I just screenshotted the movie into two pics, where you can see the wobbling: