Painted Version of ChelseyCreatesThings Cute Murder Corn from Thangs.
2 versions are Uploaded. One for a single  AMS with a color swap mid-print and one for the ballers with 2 AMS units.

Both models are scaled down to 50mm in height. If you want to scale the Single AMS version up you have to change the pause height as well. 
Support is necessary. 

How To Print On Single AMS:

1. Load filament profiles
2. Confirm pause is in the correct location:
   The pause should be after the yellow section but before the eyes/blood.
3. Check flushing volumes:
   You want to make sure that before you print the filament with the highest flushing volume is selected out of yellow and red. This way, when you do change from yellow to red, the flushing volumes are correct. 
4. Start Printing.
5. During the pause, change out the yellow filament for the red filament. 
6. Continue printing!

The eyes can either be Red or Orange.