Slightly taller thin box
Remixed by
Copyright Claim
Slightly taller thin box
Remixed by
Boost
1
4
1
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
36 min
2 plates
Boost
1
4
1
0
13
13
Released
Description
I made the walls on the thin box 1.5mm taller than previously. Ajusted the bow to fit by also increasing the width by 1.5mm. The top is the same as the original thin model.
Comment & Rating (1)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
I wish the lid was slightly thicker, because you can see gift card details through it! But it was good.
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld