Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
Open in Bambu Studio
Boost
74
109
9
1
125
37
Released
Description
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Tough Black Transmission Distance: 0.6
PLA BambuLab Tough Vermilion Red Transmission Distance: 3
PLA BambuLab Matte Scarlet Red Transmission Distance: 2
PLA BambuLab Tough Cream White Transmission Distance: 10
Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Vermilion Red
At layer #18 (1.52mm) swap to Scarlet Red
At layer #28 (2.32mm) swap to Cream White for the rest.
Comment & Rating (9)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
nice print. thanks.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Make some change of colors but it looks good again
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
not bad at all
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Printed really nice the bottom was a little thin and flexed a lot so use caution when removing it
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld