This is a custom parts collection for the ITX PC case FormD T1, including handles, feet, and rear panel spacers.

To assemble you need:

• each Handle 3x M3x8mm screws, 3x M3 hex nuts
• each Feet 2x M3x8mm screws, 2x M3 hex nuts
• GPU spacer 2x M3x4mm screws
• M/B panel spacer 2x M3x6mm screws, 2x M3 hex nuts

Assembly Handle:
Secure the handle to the top panel using M3 screws and nuts. While it's possible to directly use nuts on panel, I recommend using a 'nut bracket' to avoid scratching the panel. The handle has versions for the front and rear, so be careful not to mix them up! 

Assembly Feet:
Secure the legs to the bottom panel using M3 screws and nuts. While it's possible to directly use nuts on the panel, I recommend using a 'nut bracket' to avoid scratching the panel.

Assembly GPU Spacer:
Print spacers according to the size of the GPU you will use and fix them with M3 screws.

Assembly M/B Spacer:
Secure the M/B spacers using M3 screws and nuts.

Assembly M19 Cover:
Print a design of your choice, either A or B, and fit it into the M19 hole.
 

Note:

• My case version is v2.0, and it accommodates a 67mm CPU cooler and uses in GPU 2 slot mode. 'GPU_Spacer_B20.stl' fits perfectly.