Gridfinity baseplates for Harbor Freight parts organizer - medium (cut)
Remixed by
Copyright Claim
Gridfinity baseplates for Harbor Freight parts organizer - medium (cut)
Remixed by
Boost
6
16
5
Print Profile(2)
Minimal 0.2mm layer, 2 walls, 15% infill
3.1 h
5 plates
Skeletonized 0.2mm layer, 2 walls, 15% infill
7.5 h
5 plates
Boost
6
16
5
0
30
103
Released
Description
This baseplate fits the Harbor Freight medium sized small-parts organizer (this one). I took the original one piece model and cut it into 5 pieces to fit on the Bambu build plate.
The placement/orientation is as follows:
- hf_medium_min_base-p1 = Main Center
- hf_medium_min_base-p2 = Right Rear
- hf_medium_min_base-p3 = Left Rear
- hf_medium_min_base-p4 = Right Front
- hf_medium_min_base-p5 = Left Front
- hf_medium_skel_base-p1 = Main Center
- hf_medium_skel_base-p2 = Right Rear
- hf_medium_skel_base-p3 = Left Rear
- hf_medium_skel_base-p4 = Right Front
- hf_medium_skel_base-p5 = Left Front
The orientation assumes the handle of the organizer is facing you.
You can superglue the pieces together but the tolerances are such that they should just press fit together assuming you use the install order of 1 to 5.
Comment & Rating (5)
All
Do the 6u boxes fit against the top to prevent spill out?
The designer has replied
0
Reply
I'm using the 6u boxes and have yet to have issues
0
Reply
Print Profile
Minimal 0.2mm layer, 2 walls, 15% infill
printed perfectly on A1. Thank you!
0
Reply
I printed part 4 and the bins are a very tight fit. I don't think this grid would allow pulling the bins out without disrupting the entire section.
(Edited)0
Reply
Print Profile
Minimal 0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld