Check out my new Stortrooper model:
https://makerworld.com/en/models/435381
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.
Start with Black
At layer #10 (0.88mm) swap to Gray
At layer #14 (1.2mm) swap to White for the rest.
___________________________________________________________________________________
If you like my work, please consider a small donation :) Thank you very much :*
https://www.paypal.com/donate/?hosted_button_id=RWRXKCAEM86K8
Store: https://thinkto3d.etsy.com
Commercial license: https://patreon.com/Think_3D/membership