SpongBob on the front of the extruder that rolls one eye while printing.

Before you start printing, make sure you have a clean plate (Wash it in warm soapy water or IPA). The first layer has a lot of small elements that must stick well to the plate.

If you have printed it, please leave a rating.

Before installation, the original front and the rotating element must be dismantled.
During installation, the eye should be pressed as far as it will go. After putting the face, the eye should be flush with the face or deeper.
When assembling, make sure that the top latches are flush with the top edge before pressing from the front.

If you think that standard hooks are too weak and may break, print a version with reinforced fasteners.
You will see details in the photos below.
 

See my other projects.

Assembly instructions below.

Version with strong top fasteners.