Držák mobilu Xiaomi Mi 11 na stavit a fotografických filtrů 72mm.
Pokud upravíte díru ve sliceru, lze použít i na jiné telefony.
Testováno na filtru hoya 72mm ND 1000 (Nutno použít “Kryt vnější” . HOYA filtr CIR-PL 72mm, vejde se dovnitř takže použijte “kryt vnitřní”.
“Kryt vnější” a “kryt vnitřní” doporučuji tisknout z TPU ale postačí i PLA (u “krytu vnejši” zvěčte min o 2% pokud tisknete z PLA )
Velikost všech častí držáku jsem nechal původní, ale po vytisknutí měl mechanizmus odpor a vyžadoval broušení aby šel hladce, proto doporučuji tisknout velké víčko “vickoBIG”.
Stativová patka je na stativ hama, jinak je i verze z ¼" závitem.
Mobil musí být excentricky kvůli tlačítkům.
EN
Xiaomi Mi 11 mobile phone holder for settings and photo filters 72mm.
If you modify the hole in the slicer, it can also be used on other phones.Tested on a hoya 72mm ND 1000 filter (Must use "Outer cover". HOYA CIR-PL 72mm filter, fits inside so use "inner cover"."Outer cover" and "inner cover" I recommend printing from TPU, but PLA will also suffice (for the "outer cover" increase min by 2% if printing from PLA)
I left the size of all the parts of the holder original, but after printing the mechanism had resistance and required grinding to go smoothly, so I recommend printing a large "vickoBIG" cap.
The tripod foot is for a hama tripod, otherwise there is also a ¼" threaded version.
The mobile must be eccentric because of the buttons.