Foldable laptop stand by Josemari

Josemari

Household>Office

GIF

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

A1 mini

0.2mm layer, 2 walls, 15% infill

Designer

3 h

1 plate

4.9(107)

0.16mm layer, 4 walls, 20% infill

6.5 h

1 plate

4.9(14)

0.2mm layer, 2 walls, 10% infill, A1 mini

3.1 h

1 plate

4.6(28)

Open in Bambu Studio

Boost

277

474

181

1.4 k

1.1 k

Released

Description

A simple foldable laptop stand designed to be printed without supports.

Highly recommended installing 4 anti-slip pad in the base. There are four joggles in the design for this purpose. I have them installed in mine (If you see the gif you can notice these pads) and works really great in my office desk

Comment & Rating (181)

@user_875934616

Print Profile

0.2mm layer, 2 walls, 10% infill, A1 mini

Printed on an A1 mini with textured bed. Overall pretty good, one-piece print wasn't too tricky to get moving. A few slight floors in places, but not a game-changer for something which won't be seen underneath a laptop.

@user_3240141245

Print Profile

0.2mm layer, 2 walls, 10% infill, A1 mini

base a bit wiggly

@N0rdLightz

That’s due to your used filament and infill, not the problem of the file/creator.

@Adynko_printer

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

super

@spadesign

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed the laptop stand on the A1 mini. It is on the limit of the print plate, but the stand fits very wel under my 13" laptop. A very nice model and definitely worth printing! Thank you!

@3dprinting4silv

Print Profile

0.2mm layer, 2 walls, 15% infill

works perfect. very low profile.

@Juseda

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

excellent finish

Show original

@Ruarc_

Boosted

Print Profile

0.16mm layer, 4 walls, 20% infill

printed perfectly and looks dope! I minimized the supports a bit and added some ironing on the flat surfaces. Thanks for the design!

@nickthesail0r

Boosted

Perfect Desighn However dont print it with PLA its going to melt after a while. My Laptop is 15.6 Alienware M15 so when CPU and GPU are at 100% you can fried an egg😂😂😂😂😂

@htalves

Print Profile

0.16mm layer, 4 walls, 20% infill

Perfect outcome

@leslie.langhorn

Print Profile

0.2mm layer, 2 walls, 15% infill

Not a bad print. The under sides of the arms aren't pretty, but not generally going to be looked at. I sent the profile to print from handy, which failed after a few layers - one of the smaller parts popped off with spaghetti abound and the rear side didn't adhere well either. Downloaded to the laptop, updated the profile for my filament, added extra wall and changed infill to adaptive cubic (from grid), and it's come out well. Hinge was messy as others have said with unnecessary material.

(Edited)