Contact lens holder
Copyright Claim
Contact lens holder
Boost
20
27
11
Print Profile(1)
0.28mm layer, 2 walls, 10% infill
Designer
7.6 h
3 plates
Open in Bambu Studio
Boost
20
27
11
1
33
34
Released
Description
Easy to print without supports (the angles are 45°), it can hold most contact lenses. There is a single version if you wear two identical lenses or if you want to print it in different colors for each eye. There is also a version with L and R debossed.
Comment & Rating (11)
All
Print Profile
0.28mm layer, 2 walls, 10% infill
(Edited)
1
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
Super convenient, I can't share a photo without exposing my messy sink 🙈
10/10 though thank you!
The designer has replied
1
Reply
Thank you for the review! 😂
0
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
very good profile, had zero issues on my p1s
1
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
Very cool little print. We use it for lens wipes on the living room entrance table.
0
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
1
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 10% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
© 2024 MakerWorld