Bugbear 28mm (supportless, FDM friendly)
Copyright Claim
Bugbear 28mm (supportless, FDM friendly)
Boost
16
32
5
Print Profile(2)
0.2mm nozzle, 0.06mm layer, 3 walls, 10% infill
1.7 h
1 plate
0.2mm nozzle, 0.06mm layer, 3 walls, 10% infill
1.8 h
1 plate
Open in Bambu Studio
Boost
16
32
5
0
54
25
Released
Description
Supportless Bugbear with a club/mace.
Suitable for 28mm tabletop games.
Created so that it does not need any supports and prints well on a cheap FDM 3d printer like the Ender 3.
There are variants with square and round bases.
NOTE
The other bugbear seen in one of the photos is available on my Patreon.
Let me know how it printed for you in the comments and makes!
This and other uploads are possible thanks to my wonderful Patrons.
If you enjoy it, buy me a drink once in a while and support more supportless models on Patreon!: https://www.patreon.com/BriteMinis
Category: GamesComment & Rating (5)
All
Print Profile
0.2mm nozzle, 0.06mm layer, 3 walls, 10% infill
nice details
0
Reply
Print Profile
0.2mm nozzle, 0.06mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm nozzle, 0.06mm layer, 3 walls, 10% infill
Other Issues: layer adhesion in the base was not too great although we used silk we will later. Try it with a basic filament and rate it again.
0
Reply
Print Profile
0.2mm nozzle, 0.06mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm nozzle, 0.06mm layer, 3 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld