Coronavirus Beholder 28mm (No supports, FDM friendly) by Brite Minis

Brite Minis

Toys & Games>Characters

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.12mm layer, 2 walls, 10% infill

1.2 h

1 plate

4.8(13)

Boost

Released

Description

*NOTICE: I reuploaded the correct file - uploaded wrong file earlier that could cause slicing problems*

Because it had to be done.

The CoronaBeholder is a particularly nasty floating bag of eyeballs. Now, it can't transmit any diseases via droplets because it doesn't have a nose to sneeze. Just don't touch its spike proteins, except with the tip of your sharp magic sword, or a well aimed fireball. So get your company together and kick those teeth in.

Created so that it does not need any supports and prints well on a cheap FDM 3d printer like the Ender 3.

NOTE a supportless Beholder without the spikes is available on my Patreon.

This and other uploads are possible thanks to my wonderful Patrons.

If you enjoy it, buy me a drink once in a while and support more supportless models on Patreon!: https://www.patreon.com/BriteMinis

Follow me on Facebook and Instagram!

Category: Games

Comment & Rating (16)

@skullii

Print Profile

0.12mm layer, 2 walls, 10% infill

no support and even after a layer of primer looks great very smooth print

@spatialalchemy

Print Profile

0.12mm layer, 2 walls, 10% infill

I'd be very tempted to enlarge this model if I was to print it again. it's a little small for a beholder. that said, it printed great on my p1s. plenty good enough for my table. had an old school beholder vibe that I really dig.