Phone stand larger with cable cutout Remixed by Frederik9302

Remixed by

Frederik9302

Hobby & DIY>Electronics

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 15% infill, manual support, custom seams

Designer

2.9 h

1 plate

4.9(14)

Open in Bambu Studio

Boost

Released

Description

I made some changes to the original model to have fewer overhangs, so the tradeoff is that it uses a little bit more material.
I found that every other phone stand only allowed for charging cables that are able to bend a lot.

Therefore, this phone stand raises the phone more than a lot of other stands to account for cables with a larger bend radius than most phone stands.

Comment & Rating (14)

@3Dreamworld

Print Profile

0.2mm layer, 3 walls, 15% infill, manual support, custom seams

The print quality in PLA of the phone holder is excellent, although it does have some minor imperfections, particularly where the support structures detach and along the charger cable guide. Additionally, I wouldn't recommend using the holder for extended gaming sessions as the hand position can become uncomfortable and fatigue easily sets in. Nevertheless, for regular use, it's still a good product.

(Edited)

@Chessji

Print Profile

0.2mm layer, 3 walls, 15% infill, manual support, custom seams

The stand is really thick and supports came off clean and easy. It did not fit my phone with an Otterbox. I cut the front peice off and it held my phone fine. I found it held my iPad great also after cutting off the front peice. I love the cable holder, helps keep the cable available when I need to charge it.

(Edited)