Search models, users, collections, and posts
ABB Tango Zigbee Switch
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
55 min
1 plate
Open in Bambu Studio
Boost
1
5
0
0
4
0
Released
Description
This model allows you to fit a Zigbee switch with dimensions of 50×50×8 mm from Aliexpress into an ABB Tango cover.
The battery can be easily replaced—simply remove the front plate with a screwdriver and twist it to the left to unlock.
It is important to purchase the exact model from Aliexpress that has a bottom section to lock it into place on the back of the 3D print.
Installation steps:
- Remove the bottom cover from the Zigbee switch.
- Place the switch into the 3D-printed holder and twist it to the right to secure it.
- Attach the 3D-printed model with the Zigbee switch to the ABB Tango cover and secure it with screws.
- Insert the 3D-printed front plate into the ABB Tango cover.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)