This is a nice shelf with wall mounted bracket, honeycomb pattern and inward angled sides!

The area where the holes for the screws are placed is reinforced with 100% infill. This way you don't have to worry about damaging anything when tightening the screws.

Some woodscrews of 5mm diameter and the corresponding wall- pegs will be needed to mount the bracket to the wall.

Print instructions:

• nozzle 0,40mm
• manual tree support is recomended only for the mounting holes of the bracket, the honeycomb pattern dosn’t need support
• layer height 0,20mm
• 2 wall loops
• top/bottom shells 4 layers
• top/bottom shell thickness 0,80mm
• sparse infill 10%
• sparse infill pattern “gyroid”
• set brim to “outer brim only”
• brim width 5mm

Before printing, make sure your build plate is clean and apply some adhesive. Wash the build plate with oil free soap and wipe it off with some paper towels. For build plate adhesion, apply a thin, even coat of your preferred adhesiv. I repeat the process every 5-6 prints.

Before printing, make sure your build plate has a decent adhesion. Aftermarket plates like the ones from alibaba haven’t good adhesion. Curling will probably occur if you don’t use original build plates! Bad build plate adhesion is not related to the model or the design!

Please have a look at my other models and leave me a like if you were satisfied with your print and the design. Thank you in advance!