3D Printed Tape Measure Holder adjusted for EU sizes Remixed by piranha

Remixed by

piranha

Household>Office

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

38 min

1 plate

4.6(10)

Open in Bambu Studio

Boost

118

117

Released

Description

📏 3D Printed Tape Measure Holder for typical 15-18 mm Wide, 182 cm Tape 📏

It has been adapted to work with European tape sizes.

Check out this cool 3D printed holder for your soft tape measure! It's perfect for tapes that are 18 mm wide and 150 cm long.

🔸 Just Right for Your Tape: Made specially for 18 mm wide, 150 cm long tapes. It holds your tape just right.

🔸 Strong and Lasts Long: We use tough materials to make sure it can handle lots of use.

🔸 Easy to Put Together: Just use a bit of super glue to stick the pin in the center, and you're all set.

🔸 Handy and Small: It's easy to carry around in your pocket or toolbox.

🔸 Keeps Your Tape Neat: No more tangled tapes! This holder keeps your tape nice and tidy.

Comment & Rating (15)

@bshirley

I had a 13mm wide by 150mm long tape. I edited the Z value in Bambu studio, lowering it almost 3mm to 24mm total. (Could have gone another.) The supports were a wee rough to remove but the attachment spot will be covered, and the bottom fit in fine. A1 0.20 mm Standard, tree slim support, plate only MiKA3D Silk Red/Silk Black - Silk Shiny Double Color PLA 42 minutes, 17g

(Edited)