Wall mountable 4 Remote Control Holder
Remixed by
Copyright Claim
Wall mountable 4 Remote Control Holder
Remixed by
Boost
3
12
6
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
3.6 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
3
12
6
0
35
17
Released
Description
Wall mountable 4 remote control holder.
Different heights to the compartments to store sifferent remotes,
I made it taller & adjusted the pocket sizes from the original design
https://www.printables.com/model/684683-remote-control-holder
Should print fine without supports on the screw holes
Resubmitted the .3mf to include all printers except the mini
Wall mountable 4 remote control holder.
Different heights to the compartments to store sifferent remotes,
I made it taller & adjusted the pocket sizes from the otiginal design
Comment & Rating (6)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
The designer has replied
0
Reply
thanks for the 5 stars, glad it printed ok and you like it
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Print profile acted as if it were pieces unconnected and individually printing directly next to each other. Quite strange, I’ve not had this issue before or after and I didn’t make any changes. I had to cancel, things were getting a bit wild. Sorry I forgot to take a picture.
(Edited)The designer has replied
0
Reply
not sure what happened there, I've printed this profile a few times and so have others, could you try again?
0
Reply
Replying to @ninja
Absolutely, I will here in a bit and will update if all goes well. fixed typos in my original post lol 🤦🏻♂️
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld