The Starry Night - HueForge
Boost
299
542
61
Print Profile(3)
6 COLOR AMS, 0.2mm layer, 2 walls, 15% infill
7.1 h
1 plate
4 Colors AMS, 0.08mm layer, 3 walls, 100% infill
12.3 h
1 plate
0.2mm layer, 2 walls, 100% infill
6 h
1 plate
Boost
299
542
61
2
693
167
Released
Description
Print at 100% infill with a layer height of 0.2mm with a base layer of 0.2mm. Also, use a brim to prevent lifting in corners.
Filaments Used(Try to use similar colors to match my print):
Black - Hatchbox PLA
Dark silk blue - Generic PLA
Light blue - HatchboxPLA
Orange - Hatchbox PLA
Yellow - HatchboxPLA
White - Hatchbox PLA
Filament Swap Instructions:
Black until layer #9 at 1.8mm
Dark blue until layer #12 at 2.4mm
Light blue until layer #13 at 2.6mm
Orange until layer #14 at 2.8mm
Yellow until layer #16 at 3.2mm
White for the rest.
Note: If resizing STL, leave STL's z-height the same.
Comment & Rating (61)
All
4 colors. 15hours.
The designer has replied
1
Reply
looks great!
1
Reply
Did you make the frame by yourself? Thx
0
Reply
No, I just stuck it on a frame lol
0
Reply
Print Profile
4 Colors AMS, 0.08mm layer, 3 walls, 100% infill
good
The designer has replied
2
Reply
Hi there Sir, would you mind if i used your picture as the print profile main picture?
0
Reply
Replying to @Botaz19
sure you are free to use
0
Reply
Replying to @ak48disk
Thank you kindly <3
0
Reply
wooooow 600x400mm
thanks
2
Reply
Good afternoon. Can you explain how you cut it without losing the paint? Thanks
1
Reply
Replying to @Danielgsb
I cut it with the cutting option that bambu studio comes with, it is simple, then you put the colors by hand using the instructions, I hope it has been helpful
0
Reply
Print Profile
6 COLOR AMS, 0.2mm layer, 2 walls, 15% infill
great print
(Edited)
2
Reply
Amazing！
1
Reply
Print Profile
6 COLOR AMS, 0.2mm layer, 2 walls, 15% infill
Fantastic print! I used Hatchbox black PLA sparkle, PolyLite PLA galaxy dark green, Monoprice light blue PLA+, CC3D silk orange PLA, Bambu yellow basic PLA and Amazon Basics white silk PLA
1
Reply
Print Profile
4 Colors AMS, 0.08mm layer, 3 walls, 100% infill
What can I say. gorgeous
(Edited)
1
Reply
Print Profile
6 COLOR AMS, 0.2mm layer, 2 walls, 15% infill
came out pretty great for me! though I definitely used 100% infill
(Edited)
1
Reply
Print Profile
6 COLOR AMS, 0.2mm layer, 2 walls, 15% infill
Gorgeous, little shuffling spools with one AMS but totally worth it
1
Reply
4colors worked great
1
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld